INSTA360 X5 Invisible Dive Case Pro

INSTA360 X5 Invisible Dive Case Pro

Invisible Dive Case Pro

Perfect for the deep sea.

Capture every detail

Made with the highest quality glass for stunning underwater shots.

Completely invisible 360° underwater shots

Our industry-leading Invisible Dive Case is back - and better than ever! Get perfect 360° shots underwater with no blind spots.

Seamless perfection

Grab your X5, dive in and capture crystal clear 360° shots. The special dome design prevents distortion no matter how deep you go.

Explore the deep sea

Improved design and IPX9K - for shooting up to a depth of 50m.

Comes with the underwater storage bag as standard

The quick-drying storage bag can be used both on land and underwater, protects your dive housing from bumps and scratches and can be attached to a Buoyancy Control Device (BCD).

Built by Insta360. Tested for depth

Rigorously tested for optical clarity and durability so you can dive with confidence.

Notes

1. Do not open the dive case while it is wet.
2. After using the Invisible Dive Housing in salt water, clean it as follows:
3. Remove the camera and close the dive housing securely.
4. Soak the housing in fresh water for 5-10 minutes to prevent salt crystals from crystallizing in the gaps.
5. These salt crystals do not dissolve in water and can cause unevenness in the rubber seal, which could allow water to penetrate
6. . Then rinse the housing carefully under running water.
7. You must not expose the immersion housing to a strong jet of water from a single direction, as this could cause water to penetrate
8. . After rinsing, wipe off any water droplets that are still on the outside with a soft, dry cloth.
9. Before drying, make sure that there is no sand left on the immersion housing, as sand can scratch the product surface when wiping
10. . Do not dry the immersion housing with a hair dryer or other heat source, as this can damage it.
11. Do not clean the immersion housing with soapy water, neutral detergents, alcohol or organic solvents (such as thinner or petrol), as this may impair its watertightness
12. . Do not rinse out the inside of the immersion housing while diving. Only rinse it out when you have finished diving. After rinsing, dry the lenses and the opaque screen with a clean, dry towel and leave the housing open to air dry.
13. Before using it again, make sure it is completely dry to prevent fogging
14. . To avoid discoloration or stains on the immersion housing, avoid contact with cosmetic products such as sunscreen, make-up foundation and hand cream.
15. Do not store the immersion housing in a hot or humid environment. Above all, do not leave it in a hot car.
16. Store the product in a dry and well-ventilated place.